Face
| A03-Face-Plate | |
|---|---|
| Suggested layer height | 0.2 mm |
| Suggested infill percentage | 40%-50% |
| Supports | None |
| Number of this part for one arm pib | 1 |
| Number of this part for two arm pib | 1 |
| Mass – (Mass with supports) | 62 g |
| Printing time | 2h 30min |
| Suggested orientation |   |
| After printing processing | None |
| A01-Face | |
|---|---|
| Suggested layer height | 0.2 mm |
| Suggested infill percentage | 20%-30% |
| Supports | None |
| Number of this part for one arm pib | 1 |
| Number of this part for two arm pib | 1 |
| Mass – (Mass with supports) | 320 g |
| Printing time | 12h 20min |
| Suggested orientation |  |
| After printing processing | Remove print helpers Gently move small plastic parts highlighted until breaking  |
Only needed in advanced neck (virtual sphere)
