Standalone arm project

A83-Stand-front
Latest version downloadpib-stls/A-Head/A83-Stand-front.stl at main · pib-rocks/pib-stls · GitHub
Stable release downloadpib-stls/A-Head/A83-Stand-front.stl at main · pib-rocks/pib-stls · GitHub
Suggested layer height0.25mm
Suggested infill percentage20%-30%
SupportsNone
Number of this part for one arm pib2
Number of this part for two arm pib2
Mass – (Mass with supports)56g
Suggested orientation
After printing processingNone
A84-Arm_stand_back
Latest version download
Stable release download
Suggested layer height0.25mm
Suggested infill percentage20%-30%
SupportsNone
Number of this part for one arm pib1
Number of this part for two arm pib1
Mass – (Mass with supports)258g
Suggested orientation
After printing processingNone
A85-Arm_stand_back_cover
Latest version download
Stable release download
Suggested layer height0.25mm
Suggested infill percentage20%-30%
SupportsNone
Number of this part for one arm pib1
Number of this part for two arm pib1
Mass – (Mass with supports)164g
Suggested orientation
After printing processingNone
A87-Arm_stand_rotator
Latest version download
Stable release download
Suggested layer height0.25mm
Suggested infill percentage20%-30%
SupportsNone
Number of this part for one arm pib1
Number of this part for two arm pib1
Mass – (Mass with supports)87g
Suggested orientation
After printing processingNone
A89-Arm_stand_LCD_holder
Latest version download
Stable release download
Suggested layer height0.25mm
Suggested infill percentage20%-30%
Supportspaint on supports
Number of this part for one arm pib1
Number of this part for two arm pib1
Mass – (Mass with supports)225g
Suggested orientation
After printing processingNone
A86-Arm_stand_scaffold
Latest version download
Stable release download
Suggested layer height0.25mm
Suggested infill percentage20%-30%
SupportsNone
Number of this part for one arm pib1
Number of this part for two arm pib1
Mass – (Mass with supports)28.5g
Suggested orientation
After printing processingNone
A86-Arm_stand_wire_cover
Latest version download
Stable release download
Suggested layer height0.25mm
Suggested infill percentage20%-30%
SupportsNone
Number of this part for one arm pib1
Number of this part for two arm pib1
Mass – (Mass with supports)4g
Suggested orientation
After printing processingNone

Nach oben