Face

A03-Face-Plate
Suggested layer height0.2 mm
Suggested infill percentage40%-50%
SupportsNone
Number of this part for one arm pib1
Number of this part for two arm pib1
Mass – (Mass with supports)62 g
Printing time2h 30min
Suggested orientation
After printing processingNone

A01-Face
Suggested layer height0.2 mm
Suggested infill percentage20%-30%
SupportsNone
Number of this part for one arm pib1
Number of this part for two arm pib1
Mass – (Mass with supports)320 g
Printing time12h 20min
Suggested orientation
After printing processingRemove print helpers

Gently move small plastic parts highlighted until breaking

Only needed in advanced neck (virtual sphere)

Nach oben